Select “Operations,” then “Read Out Vehicle Data,” and finally “Complete Identification.Choose the “VCI Config” tab, then “Ediabas standard settings (ediabas.ini)” and “OK.”.Run BMW Rheingold ISTA from the start menu, wait until it boots, and then press the settings button.Connect the car to the PC using the K+D-CAN cable.Open Notepad and look for “Port=Com9” in “C:EDIABASBINOBD.INI”.Check for “Interface = “STD:OBD” in INI with Notepad. Par contre je souhaiterai faire un test de débit des injecteurs ainsi que le test de mon débitmètre. Tout semble fonctionner puisque jarrive à identifier mon véhicule de façon complete. Open “Device Manager,” then “USB Serial Port Properties,” then “Port Settings” and “Advanced…” Change the port to “COM9” and the latency timer to “1.” Confirm configuration by clicking the “OK” button. Bonjour, jai installé ISTA D selon le tuto fourni avec les fichiers téléchargés.Use the most recent drivers for FTDI-based cables. Connect your K+D-CAN cable and install the drivers.EDIABAS = Low-Level ECU Communication Software Server used by ISTA+Ĭonfiguration K+DCAN with BMW ISTA procedures.
0 Comments
Leave a Reply. |